Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install a front OCP module.
Note: Ensure that the Ethernet adapter is fully seated, and the thumbscrew is securely tightened.
Otherwise, the OCP module will not get full connection and may not function.
Figure 113. Installing the front OCP module
a. Push the OCP module by its handle on the left until it is fully inserted into the connector on
the front OCP interposer card.
b.
Fully tighten the thumbscrew to secure the adapter. Use a screwdriver if needed.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 288.
OCP interposer card replacement
Follow the instructions in this section to remove or install the front and rear OCP interposer cards.
• “Remove the front OCP interposer card” on page 120
Chapter 5. Hardware replacement procedures 119
To Next Page
Loading...
