Install the front I/O module
Use this information to install the front I/O module.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install the front I/O module.
Figure 119. Install a front I/O module on 2.5'' chassis
a. Insert the front I/O module into the front chassis.
b.
Install the screws to secure the front I/O module in place.
After you finish
1. Connect the front I/O cables to the processor board. See
Internal Cable Routing Guide.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Heat sink Torx T30 nut replacement
Use this information to remove and install a heat sink Torx T30 nut.
Chapter 5. Hardware replacement procedures 125
To Next Page
Loading...
