Step 3. Remove the inner rails from the server.
Figure 69. Removing the inner rails
a. Flip the touch point to unlock the inner rail.
b.
Push the inner rail backwards until the T-pins on the server disengaged from the inner rail.
Step 4. Repeat the previous step to the other rail.
After you finish
Carefully lay the server on a flat, static-protective surface.
Install the server to the rack (friction rails)
Follow instructions in this section to install the server to the rack.
S036
18 - 32 kg (39 - 70 lb) 32 - 55 kg (70 - 121 lb)
CAUTION:
Use safe practices when lifting.
R006
Chapter 5. Hardware replacement procedures 85
To Next Page
Loading...
