Step 2. Connect the cables to the system board assembly and the backplane. See Internal Cable Routing
Guide
. If the cable connectors come with protective dust caps, make sure to remove them before
plugging in.
Step 3. Install the air baffle into the rear hot-swap drive cage as shown.
Figure 94. Air baffle installation
a.
Align the air baffle edge with the notch on the drive cage.
b. Press the air baffle down and make sure that it is seated in place.
After you finish
1. Reinstall drives or drive fillers into the rear hot-swap drive cage. See “Install a 2.5-inch hot-swap drive”
on page 130
.
2. Reinstall the drive assembly to the server. See
“Install the 2.5-inch rear drive assembly” on page 233.
3. Complete the parts replacement. See
“Complete the parts replacement” on page 288.
CMOS battery (CR2032) replacement
Use this information to remove and install the CMOS battery (CR2032).
•
“Remove the CMOS battery (CR2032)” on page 105
• “Install the CMOS battery (CR2032)” on page 107
Remove the CMOS battery (CR2032)
Use this information to remove the CMOS battery.
About this task
The following tips describe information that you must consider when removing the CMOS battery.
Chapter 5. Hardware replacement procedures 105
To Next Page
Loading...
