Note: Before you install the battery into the socket, make sure that the positive side faces upward.
1.
Tilt the battery and insert it to the socket.
2.
Press the battery down until it clicks into the socket.
Figure 96. CMOS battery installation
After you finish
1. Complete the parts replacement. See “Complete the parts replacement” on page 288.
2. Use the Setup Utility to set the date, time, and any passwords.
Front adapter assembly replacement
A complete front adapter assembly consists of two front riser cages, two front riser cards and two PCIe
adapters. See this topic to understand how to remove and assemble a front adapter assembly.
Server front configuration and riser assemblies
See this section to identify the correlations between the front configuration and riser assemblies.
Table 33. Server front configuration and riser assemblies
Server front configuration Riser 3 assembly Riser 4 assembly
Figure 97. Two front PCIe slots
Figure 98. LP riser bracket
Figure 99. Riser card
Figure 100. FH riser bracket
Figure 101. Riser card
•
“Front riser cage replacement” on page 109
• “Front riser card and PCIe adapter replacement” on page 112
Front riser cage replacement
Follow instructions in this section to remove and install the front riser cage.
Chapter 5. Hardware replacement procedures 109
To Next Page
Loading...
