• To order replacement batteries, call your support center or business partner. For Lenovo support
telephone numbers, see
https://datacentersupport.lenovo.com/supportphonelist for your region support
details.
Note: After you replace the CMOS battery, you must reconfigure the server and reset the system date and
time.
S004
CAUTION:
When replacing the lithium battery, use only Lenovo specified part number or an equivalent type of
battery recommended by the manufacturer. If your system has a module containing a lithium battery,
replace it only with the same module type made by the same manufacturer. The battery contains
lithium and can explode if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100°C (212°F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Attention:
• Read “Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install the CMOS battery. Ensure that the CMOS battery is seated in place.
108
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
