Figure 290. FH riser card Figure 291. BF cabled riser
card
Figure 292. BF riser card Figure 293. LP riser card
Remove a rear riser card
Use this information to remove a rear riser card.
About this task
For more riser brackets supported, see
“Rear riser card replacement” on page 251.
The riser assembly to remove might be different from the following illustrations, but the removal method is
the same. The following takes the LP-FH riser assembly as an example.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 282.
Step 2. If there is any PCIe adapter installed on the riser card, record the cable connections first. Then,
disconnect all cables from the PCIe adapter.
Step 3. Remove the riser assembly.
Chapter 5. Hardware replacement procedures 255
To Next Page
Loading...
