• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install the front backplane. Align the two pins on the backplane with the corresponding holes in the
chassis. Lower the backplane into the chassis.
Note: Make sure that both edges of the backplane slide into the metal rails as illustrated below.
Figure 90. Installation of backplane for ten 2.5-inch hot-swap drives
Step 2. Connect the cables to the system board assembly and the backplane. See Internal Cable Routing
Guide
. If the cable connectors come with protective dust caps, make sure to remove them before
plugging in.
After you finish
1. Reinstall all the drives and drive fillers into the drive bays. See “Install a 2.5-inch hot-swap drive” on
page 130
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Remove the 2.5-inch rear drive backplane
Use this information to remove the 2.5-inch rear drive backplane.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
102
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
