a. Open the ipmitool and enter the following command to disable the SOL feature:
-I lanplus -H IP -U USERID -P PASSW0RD sol deactivate
b. Open Windows PowerShell and enter the following command to disable the Emergency
Management Services (EMS) feature:
Bcdedit /ems off
c. Restart the server to ensure that the EMS setting takes effect.
System board assembly replacement (trained technicians only)
Follow instructions in this section to remove and install the system board assembly.
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do not
attempt to remove or install it without proper training and qualification.
S017
CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
CAUTION:
The heat sinks and processors might be very hot. Turn off the server and wait several minutes to let
the server cool before removing the server cover.
The following illustration shows the layout of the system board assembly which consists of the system I/O
board and processor board.
Chapter 5. Hardware replacement procedures 267
To Next Page
Loading...
