Install the air baffle
Follow instructions in this section to install the air baffle.
About this task
Depending on the model, your server might not have an air baffle installed. The air baffle you want to install
might be different from following illustrations, but the installation method is the same.
S033
CAUTION:
Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with
metal, which might result in spattered metal, burns, or both.
S017
CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. If you need to install a RAID flash power module on the back side of the air baffle, install it first.
Step 2. Align the clips on the air baffle to the sockets on the cable walls.
Chapter 5. Hardware replacement procedures 99
To Next Page
Loading...
