Figure 304. Removing the riser bracket
a. Open the retention latch.
b.
Remove the serial port module from the riser bracket.
Step 5. (Optional) If you need to replace the serial port bracket, use a 5 mm wrench to disassemble the
serial port cable from the bracket.
Figure 305. Disassembling the serial port module
a. Loosen the two screws.
b.
Pull out the serial port cable from the bracket.
After you finish
1. Install a new serial port module, a PCIe adapter, or a PCIe slot bracket to cover the place. See
“Install a
serial port module” on page 264
and “Install a PCIe adapter” on page 218.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a serial port module
Use this information to install a serial port module.
About this task
Attention:
264 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
