Lenovo ThinkSystem SR630 V4 - Rear M.2 Assembly Replacement

Figure 239. 2.5-inch rear drive cage installation
Step 6. Connect the cables to the processor board or expansion slots. See
Internal Cable Routing Guide.
After you finish
1. Reinstall the drives or drive fillers into the 2.5-inch rear drive cage. See “Install a 2.5-inch hot-swap
drive” on page 130
.
2. Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Rear M.2 assembly replacement
Follow the instructions in this section to remove and install the rear M.2 assembly.
Figure 240. Parts of a rear M.2 assembly
236 ThinkSystem SR630 V4 User Guide