Figure 237. Rear backplane installation
Step 3. Connect the cables to the backplane.
Step 4. Install the air baffle into the 2.5-inch rear drive cage as shown.
Figure 238. Air baffle installation
a. Align the air baffle edge with the notch on the drive cage.
b.
Press the air baffle down and make sure that it is seated in place.
Step 5. Align the pins on the 2.5-inch rear drive cage with the corresponding hole and slot in the chassis.
Then, lower the 2.5-inch rear drive cage into the chassis until it is fully seated.
Chapter 5. Hardware replacement procedures 235
To Next Page
Loading...
