Note: The processor board comes with a supporting metal sheet. No further removal is needed.
After you finish
Important: Before you return the system board assembly, make sure that the processor socket is covered.
There is a processor external cap covering the processor socket on the new system board assembly. Slide
the processor external cap out from the processor socket on the new system board assembly, and install the
external cap on the processor socket on the removed system board assembly.
If you are planning to recycle the system board assembly, follow the instructions in
Appendix A “Hardware
disassembling for recycle” on page 337
for compliance with local regulations.
Install the processor board
Follow the instructions in this section to install the processor board.
About this task
A processor board provides different connectors or slots to connect different components or peripherals of
the system for communication. The board and the supporting metal sheet constitute a base for the system
board assembly. If the processor board fails, it must be replaced.
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do not
attempt to remove or install it without proper training and qualification.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install the system I/O board, see
“Install the system I/O board” on page 270.
Step 2. Install the system board assembly to the server.
276
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
