Figure 254. Installing M.2 cage
Step 3. Connect all cables to the M.2 backplane. For more information, see Internal Cable Routing Guide.
Step 4. Install the top cover, see
“Install the top cover” on page 284.
After you finish
1. Complete the parts replacement. See “Complete the parts replacement” on page 288.
2. Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
https://pubs.lenovo.com/lxpm-overview/.
Rear OCP module replacement
Use this information to remove and install the rear OCP module.
Note: The OCP module is available only on some models.
• “Remove the rear OCP module” on page 249
• “Install the rear OCP module” on page 250
Remove the rear OCP module
Use this information to remove the rear OCP module.
About this task
Attention:
• Read “Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 249
To Next Page
Loading...
