Figure 92. 2.5-inch rear drive backplane removal
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 2.5-inch rear drive backplane
Use this information to install the 2.5-inch rear drive backplane.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Align the rear backplane with the rear hot-swap drive cage and lower it into the rear hot-swap drive
cage.
Figure 93. Rear backplane installation
104 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
