Figure 111. Assembling the two riser cages
a. Tilt the low-profile cage and insert it to the latch on the full-height one.
b.
Place the low-profile cage down and align the screw holes.
c. Tighten the screw and make sure the low-profile cage is secured.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Front OCP module and OCP interposer card replacement
Some server models support the front OCP module. The front OCP module and the front and rear OCP
interposer cards are codependent. Follow instructions in this section to remove and install the front OCP
module and the front and rear OCP interposer cards.
•
“Front OCP module replacement” on page 117
• “OCP interposer card replacement” on page 119
Front OCP module replacement
Follow the instructions in this section to remove or install a front OCP module.
•
“Remove the front OCP module” on page 117
• “Install the front OCP module” on page 118
Note: The OCP module is available only on some models.
Remove the front OCP module
Follow the steps in this section to remove a front OCP module.
Chapter 5. Hardware replacement procedures 117
To Next Page
Loading...
