d. Pull the M.2 drive away from the 1 connector at an angle of approximately 30 degrees.
Step 4. Remove the M.2 module from the chassis.
Figure 136. M.2 module removal
a. Loosen the screw.
b.
Release the M.2 backplane from the pin and carefully lift the M.2 backplane out from the
chassis.
Step 5. Disconnect all M.2 cables from the processor board.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Adjust the retainer on the internal M.2 backplane
Use this information to adjust the retainer on the internal M.2 backplane.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Adjust the M.2 retainer.
Chapter 5. Hardware replacement procedures 143
To Next Page
Loading...
