Figure 297. Riser assembly installation
a. Align the clips, openings or screw holes on the riser bracket to the chassis and press the
bracket down.
b.
Tighten the screw and ensure that the bracket is securely seated.
Step 4. Connect the cables of the PCIe adapters or the riser card. See
Internal Cable Routing Guide and
locate the cable routing information.
After you finish
Complete the parts replacement. See “Complete the parts replacement” on page 288.
Security bezel replacement
Use this information to remove and install the security bezel.
Note: The security bezel is available on some models.
• “Remove the security bezel” on page 259
• “Install the security bezel” on page 261
Remove the security bezel
Use this information to remove the security bezel.
About this task
Attention:
Chapter 5. Hardware replacement procedures 259
To Next Page
Loading...
