Figure 248. Assembling M.2 interposer and drive
a. Tilt the M.2 drive assembly and insert the connector to the interposer slot.
b.
Press the drive assembly down and align a screw hole.
c.
Tighten one screw to secure the two assemblies.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Remove rear hot-swap M.2 interposer and drive assembly
Follow the instructions in this section to remove rear hot-swap M.2 interposer and drive assembly.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the rear M.2 interposer and drive assembly.
Chapter 5. Hardware replacement procedures 243
To Next Page
Loading...
