Figure 295. Riser card removal
a. Remove the three screws that secure the riser card to the bracket.
b.
Remove the riser card.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install a rear riser card
Use this information to install a rear riser card.
About this task
For more riser brackets supported, see
“Rear riser card replacement” on page 251.
The riser assembly you want to install might be different from the following illustrations, but the installation
method is the same. The following takes the LP-FH riser assembly as an example.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 257
To Next Page
Loading...
