Figure 216. Memory module installation
Attention:
• Before you install a memory module into the slot, make sure that the clips are on open position,
and the slot is clear of any debris.
• To avoid breaking the retaining clips or damaging the memory module slots, open and close the
clips gently.
a.
Open the retaining clip on each end of the memory module slot.
b.
Identify the key on the memory module and then align the key to the slot, and gently place
the memory module into the slot with both hands.
c.
Press both ends of the memory module straight down into the slot until the retaining clips
snap into the locked position.
Note: If there is a gap between the memory module and the retaining clips, the memory
module has not been correctly inserted. In this case, open the retaining clips, remove the
memory module, and then reinsert it.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 288.
MicroSD card replacement
Follow the instructions in this section to remove and install the MicroSD card.
Remove the MicroSD card
Follow the instructions in this section to remove the MicroSD card.
About this task
Attention:
• Read “Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
Chapter 5. Hardware replacement procedures 213
To Next Page
Loading...
