Lenovo ThinkSystem SR630 V4 - Page 224

• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Prepare your server.
a. Remove the top cover. See
“Remove the top cover” on page 282.
b. If your server comes with riser assemblies, remove them first, see
“Remove a PCIe adapter” on
page 216
.
c. If your server comes with a rear drive assembly, remove it first. See
“Remove the 2.5-inch rear
drive assembly” on page 232
.
d. If your server comes with a rear M.2 drive assembly, remove it first. See
“Rear M.2 assembly
replacement” on page 236
.
e. Record where the cables are connected to the system board assembly; then, disconnect all
the cables.
Attention: Disengage all latches, cable clips, release tabs, or locks on cable connectors
beforehand. Failing to release them before removing the cables will damage the cable
connectors on the system board assembly. Any damage to the cable connectors may require
replacing the system board assembly.
Step 2. Remove the MicroSD card.
Figure 217. Removing MicroSD card
a. Slide the socket lid to open position.
b.
Open the socket lid.
c.
Remove the MicroSD card from the socket.
214
ThinkSystem SR630 V4 User Guide