Figure 156. Removing the holder
a.
Loosen the screws that locks the holder to the system I/O board and processor board.
b.
Lift the holder out of the chassis.
c.
Re-install the screw back to the system I/O board and processor board.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the Lenovo Processor Neptune
TM
Core Module
Follow the instructions in this section to install the Processor Neptune
TM
Core Module (NeptCore).
Important:
• This task must be operated by trained technicians that are certified by Lenovo Service. Do not attempt to
remove or install it without proper training and qualification.
• Contact Lenovo Professional Services team for help when installing the part for the first time.
About this task
Safety information for leakage detection sensor module cable
S011
CAUTION:
Sharp edges, corners, or joints nearby.
Attention:
Chapter 5. Hardware replacement procedures 161
To Next Page
Loading...
