Lenovo ThinkSystem SR630 V4 - Page 170

Figure 154. Disengaging the hoses and module
a. Push the holder latches to both sides to unlock the module.
b.
Disengage the hoses and module from the hose holder.
Step 7. Disengage the NeptCore module from the processor board.
Figure 155. Removing the NeptCore module
a. Fully loosen the Torx T30 nuts on the cold plate assembly.
b.
Rotate the anti-tilt wire bails inward.
c.
Carefully lift the NeptCore module from the processor sockets. If the NeptCore module
cannot be fully lifted out of the socket, further loosen the Torx T30 nuts and try lifting the
NeptCore module again.
Step 8. Separate the processor from the NeptCore module. Refer to “Separate the processor from carrier
and heat sink” on page 223
.
Step 9. If there is any old thermal grease on the processors and the cold plates, gently clean the
processors and the cold plates with an alcohol cleaning pad.
Step 10. Remove the hose holder.
160
ThinkSystem SR630 V4 User Guide