a. Clean up the thermal pad residue on the back of the heat sink with an alcohol cleaning
towel.
b.
Peel off the pad on the drive tray.
c.
Clean up the residue by swiping with an alcohol cleaning towel in one direction.
Step 5. Remove the rear M.2 interposer.
Figure 244. Removing M.2 interposer
a. Loosen four screws that lock the M.2 interposer.
b.
Lift the interposer off the interposer tray.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Assemble the rear M.2 interposer and drive
Use this information to assemble the rear M.2 interposer and drive.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
240 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
