Figure 218. Installing MicroSD card
a.
Place the MicroSD card into the socket.
b.
Close the socket lid.
c.
Slide the socket lid to lock position.
After you finish
1. Install any components that you have removed:
a.
“Install a PCIe adapter” on page 218
b. “Install rear M.2 cage” on page 248
c. “Install the 2.5-inch rear drive assembly” on page 233
d. “Install the top cover” on page 284
2. Complete the parts replacement. See “Complete the parts replacement” on page 288.
PCIe adapter replacement
Use this information to remove and install a PCIe adapter.
The PCIe adapter can be an Ethernet adapter, a host bus adapter (HBA), a PCIe RAID adapter, a PCIe
interposer adapter, a PCIe solid-state drive, a PCIe GPU, and any other supported PCIe adapter.
Notes:
• Depending on different types, the PCIe adapter might look different from the illustrations in this topic.
• Use any documentation that comes with the PCIe adapter, and follow the instructions in this topic.
Remove a PCIe adapter
Use this information to remove a PCIe adapter.
About this task
Attention:
216
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
