Step 2. Disconnect all the cables connected to the M.2 backplane and record them.
Step 3. Remove the M.2 cage. Lift the cage out of the chassis.
Figure 253. Removing the M.2 cage
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install rear M.2 cage
Follow the instructions in this section to install the rear M.2 cage.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Install all parts nested in the M.2 cage, see
“Install rear hot-swap M.2 interposer and drive
assembly” on page 244
.
Step 2. Install the M.2 cage into the chassis. Align the guiding pins on the cage to the slots on the chassis.
248 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
