b. Tighten the screws.
Step 9. Connect the leakage detection sensor module cable of the NeptCore module to the connector on
the system board assembly. See
Internal Cable Routing Guide.
Step 10. Install the top cover. See
“Install the top cover” on page 284.
Step 11. To install the server into the rack, see
“Install the server to the rack (friction rails)” on page 85 and
“Install the server to the rack (slide rails)” on page 93.
Step 12. To install the quick connect plugs to the manifolds, see
“Install the manifold (in-rack system)” on
page 177
or “Install the manifold (in-row system)” on page 198.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Manifold replacement (trained technicians only)
Use the following procedures to remove and install the manifolds.
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do not
attempt to remove or install it without proper training and qualification.
Contact Lenovo Professional Services team for help when installing the part for the first time.
The liquid runs through the cooling system is de-ionized water. For more information about the liquid, see
“Water requirements” on page 13.
The server can be installed in the ThinkSystem Heavy Duty Full Depth Rack Cabinets. For ThinkSystem
Heavy Duty Full Depth Rack Cabinets User Guide, see
ThinkSystem Heavy Duty Full Depth Rack Cabinets
User Guide
.
For more operation and maintenance guidelines on Coolant Distribution Unit (CDU), see
Lenovo Neptune
DWC RM100 in-rack Coolant Distribution Unit (CDU) Operation & Maintenance Guide
.
The illustrations below present the rear views of a rack cabinet; three sets of manifolds and three sets of
connection hoses. There are two labels attached to the front of the manifolds, and one label on one end of
each hose.
168
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
