d. Release the front latch to secure the rail to the rack.
Step 3. Make sure that the rail is securely engaged in the flange holes by inspecting that the hook has
caught and by sliding back and forward to ensure the rail does not pop out.
Important: Make sure both ends of the rail are seated at the same height.
Step 4. Repeat Step 1 on page 80 to Step 3 on page 82 to install the other rail.
Step 5. Install the server to the rack, see
“Install the server to the rack (slide rails)” on page 93.
Server replacement
Follow the instructions in this section to remove and install the server.
•
“Remove the server from the rack (friction rails)” on page 82
• “Install the server to the rack (friction rails)” on page 85
• “Remove the server from the rack (slide rails)” on page 89
• “Install the server to the rack (slide rails)” on page 93
Remove the server from the rack (friction rails)
Follow instructions in this section to remove the server from the rack.
S036
18 - 32 kg (39 - 70 lb) 32 - 55 kg (70 - 121 lb)
CAUTION:
Use safe practices when lifting.
R006
82 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
