Figure 64. Installing rear mounting pins
a. Extend the outer rail toward the rear mounting flanges in the rack.
b.
Align the mounting pins with the rear mounting flanges and set the opening of the rear latch
against the rack frame.
c.
Push the rail toward outside of the rack until the rear latch opens.
d.
Push the rail toward the rear mounting flanges.
e.
Rotate the rear latch back to the closed position.
Step 2. Install the front mounting pins to the rack.
Figure 65. Installing front mounting pins
a. Slide the inner rail all the way in to allow the front latch to open.
b.
Open the front latch and align the mounting pins with corresponding front mounting
flanges.
c.
Pull the rail forward until the mounting pins go through the holes.
Chapter 5. Hardware replacement procedures 81
To Next Page
Loading...
