Remove the front I/O module
Use this information to remove the front I/O module.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 282.
Step 2. If the security bezel is installed, remove it. See
“Remove the security bezel” on page 259.
Step 3. Disconnect the front I/O cables from the processor board.
Step 4. Remove the front I/O module.
Figure 118. Remove a front I/O module on 2.5'' chassis
a. Remove the screws that secure the front I/O module.
b.
Slide the front I/O module out of the front chassis.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
124
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
