Lenovo ThinkSystem SR630 V4 - Install Rear Hot-Swap M.2 Interposer and Drive Assembly

Figure 249. Removing rear M.2 drive assembly
a.
Slide the release latch to the right to open the drive tray handle.
b.
Slide the drive out of the drive bay.
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install rear hot-swap M.2 interposer and drive assembly
Follow the instructions in this section to install rear hot-swap M.2 interposer and drive assembly.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Assemble the M.2 interposer and drive, see
“Assemble the rear M.2 interposer and drive” on page
240
.
Step 2. Install the hot-swap M.2 interposer and drive assembly to the chassis.
244
ThinkSystem SR630 V4 User Guide