Remove a serial port module
Use this information to remove a serial port module.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover. See
“Remove the top cover” on page 282.
Step 2. Disconnect the cable of the serial port module from the system board assembly.
Step 3. Remove the riser bracket.
Figure 303. Removing the riser bracket
a. Loosen the screw that locks the riser bracket.
b.
Lift the bracket out of chassis.
Step 4. Open the retention latch and remove the serial port module from the riser bracket.
Chapter 5. Hardware replacement procedures 263
To Next Page
Loading...
