Attention: Make sure to remove or install memory module 20 seconds after disconnecting power cords from
the system. It allows the system to be completely discharged of electricity and safe for handling memory
module.
Step 1. Power off the server and disconnect all power cords.
Step 2. Remove the top cover. See
“Remove the top cover” on page 282.
Step 3. If your server comes with an air baffle, remove it. See
“Remove the air baffle” on page 97.
Step 4. Remove the memory module from the slot.
Figure 215. Memory module removal
a. Open the retaining clip on each end of the memory module slot.
Attention: To avoid breaking the retaining clips or damaging memory module slots, handle the
clips gently.
b.
Grasp the memory module at both ends and carefully lift it out of the slot.
After you finish
1. A memory module slot must be installed with a memory module or a memory module filler. See “Install a
memory module” on page 211
.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a memory module
Follow instructions in this section to install a memory module.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
Chapter 5. Hardware replacement procedures 211
To Next Page
Loading...
