Note: For leakage detection sensor module working status, see “LED on the leakage detection
sensor module” on page 303
.
Step 8. Connect the leakage detection sensor module cable and pump cables of the NeptAir module to the
connector on the system board assembly. See
Internal Cable Routing Guide.
Step 9. To install the server into the rack, see
“Install the server to the rack (friction rails)” on page 85 and
“Install the server to the rack (slide rails)” on page 93.
After you finish
Complete the parts replacement. See
“Complete the parts replacement” on page 288.
Lenovo Processor Neptune
TM
Core Module replacement (trained
technicians only)
Follow the instructions in this section to remove and install the Processor Neptune
TM
Core Module
(NeptCore).
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do not
attempt to remove or install it without proper training and qualification.
Contact Lenovo Professional Services team for help when installing the part for the first time.
•
“Remove the Lenovo Processor Neptune
TM
Core Module” on page 158
• “Install the Lenovo Processor Neptune
TM
Core Module” on page 161
Remove the Lenovo Processor Neptune
TM
Core Module
Follow the instructions in this section to remove the Processor Neptune
TM
Core Module (NeptCore).
Important:
• This task must be operated by trained technicians that are certified by Lenovo Service. Do not attempt to
remove or install it without proper training and qualification.
• Contact Lenovo Professional Services team for help when installing the part for the first time.
About this task
Safety information for leakage detection sensor module cable
S011
CAUTION:
Sharp edges, corners, or joints nearby.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
158
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
