Figure 165. Installation details
• The hoses: place the middle part of the hose against the blue latch; and insert the 1 outlet and
2 inlet hoses into the holder.
• The leakage detection sensor module
3 : Insert the module to the holder beside the hoses. And
make sure that the side with a status LED is up and route the cable as illustrated above.
• For leakage detection sensor module working status, see
“LED on the leakage detection sensor
module” on page 303
.
Step 8. Close the hose holder cover.
Figure 166. Closing the cover back
a.
Close the cover in and align the screw hole.
Chapter 5. Hardware replacement procedures 167
To Next Page
Loading...
