Figure 310. System I/O board removal
a. Remove the screws that secure the system I/O board.
b.
Pinch the handle on the IO board and pull the IO board outward to disengage it from the
processor board.
After you finish
Important:
• Before you return the processor board, make sure that you install the processor socket covers to the new
processor board.
• If replacing a new system I/O board, transfer the MicroSD card from the old system I/O board to the new
one. See
“Remove the MicroSD card” on page 213 and “Install the MicroSD card” on page 215.
• If you are planning to recycle the system board assembly, follow the instructions in
Appendix A “Hardware
disassembling for recycle” on page 337
for compliance with local regulations.
Install the system I/O board
Follow the instructions in this section to install the system I/O board, also known as Datacenter-ready Secure
Control Module.
About this task
Important: This task must be operated by trained technicians that are certified by Lenovo Service. Do not
attempt to remove or install it without proper training and qualification.
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
270
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
