Procedure
Step 1. Install the system I/O board.
Figure 311. System I/O board installation
a. Align the contacts on the system I/O board with the slots on the processor board, and use
both hands to push the system I/O board and slightly insert it into the connector.
Note: To prevent the contacts of the system I/O board from damage, ensure that the system I/
O board is aligned correctly with the connector on the processor board, and remains as
horizontal as possible during the insertion.
b.
Install the screws to install the system I/O board to the supporting metal sheet.
Step 2. Install the MicroSD card, see
“Install the MicroSD card” on page 215.
After you finish
1. Install any components that you have removed before the removal of system I/O board.
•
“Processor and heat sink replacement (trained technicians only)” on page 219
• “Memory module replacement” on page 210
• “System fan-pack replacement” on page 279
• “Rear riser card replacement” on page 251
• “CMOS battery (CR2032) replacement” on page 105
• “Rear OCP module replacement” on page 249
2. Properly route and secure the cables in the server. Refer to detailed cable routing information for each
component in
Internal Cable Routing Guide.
3. Install the rear drive cage if you have removed it. See
“Install the 2.5-inch rear drive assembly” on page
233
.
4. Install the air baffle if you have removed it. See
“Install the air baffle” on page 99.
5. Install the top cover. See
“Install the top cover” on page 284.
6. Push the power supplies into the bays until they click into place.
7. Connect power cords to the server and turn on the server.
Chapter 5. Hardware replacement procedures 271
To Next Page
Loading...
