• Read “Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
• Read the
“PCIe slots and adapters” on page 65 to ensure that you install the serial port module to a
correct PCIe slot.
Procedure
Step 1. Use a 5 mm wrench to install the serial port cable into the bracket.
Figure 306. Assembling the serial port module
a. Align the two screw holes on the cable connector to the bracket.
b.
Install the two screws to the bracket.
Step 2. Install the serial port module to the riser bracket.
Figure 307. Installing the serial port module
a.
Open the retention latch on the riser cage.
b.
Install the serial port module to the riser bracket.
c.
Close the retention latch and ensure that the serial port module is securely installed.
Chapter 5. Hardware replacement procedures 265
To Next Page
Loading...
