Step 3. Install the riser assembly to the server.
Figure 308. Installing the riser assembly
a. Align the clips, openings or screw holes on the riser bracket to the chassis and press the
bracket down.
b.
Tighten the screw and ensure that the bracket is securely seated.
Step 4. Connect the cable of the serial port module to the serial-port-module connector on the system
board assembly. For the location of the serial-port-module connector, refer to
“System-board-
assembly connectors” on page 32
.
After you finish
1. Complete the parts replacement. See
“Complete the parts replacement” on page 288.
2. From the UEFI Setup page, click System Settings ➙ Devices and I/O Ports ➙ Console Redirection
Settings. Change both Console Redirection and SP Redirection setting to Enabled.
3. To enable the serial port module on Linux or Microsoft Windows, do one of the followings according to
the installed operating system:
Note: If the Serial over LAN (SOL) or Emergency Management Services (EMS) feature is enabled, the
serial port will be hidden on Linux and Microsoft Windows. Therefore, it is required to disable SOL and
EMS to use the serial port on operating systems for serial devices.
• For Linux:
Open the ipmitool and enter the following command to disable the Serial over LAN (SOL) feature:
-I lanplus -H IP -U USERID -P PASSW0RD sol deactivate
• For Microsoft Windows:
266
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
