• “Remove the front riser cage” on page 110
• “Install the front riser cage” on page 111
Remove the front riser cage
Follow the instructions in this section to remove the front riser cage.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover, see
“Remove the top cover” on page 282.
Step 2. Remove the cables connected to the processor board, see
Internal Cable Routing Guide.
Step 3. Remove the front riser cage.
Figure 102. Removing the front riser cage
a. Loosen the screw on the rear of the front riser cage.
110
ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
