Lenovo ThinkSystem SR630 V4 - Page 130

• “Install the front OCP interposer card” on page 121
• “Remove the rear OCP interposer card” on page 122
• “Install the rear OCP interposer card” on page 123
Remove the front OCP interposer card
Follow the steps in this section to remove a front OCP interposer card.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 282.
Step 2. Remove the front riser cage. See
“Remove the front riser cage” on page 110.
Step 3. Remove the front OCP module. See
“Remove the front OCP module” on page 117.
Step 4. Remove the front OCP interposer card.
Figure 114. Removing the front OCP interposer card
a. Disconnect the sideband connector to gain access to the screw underneath.
b.
Loosen four screws.
c.
Lift the front OCP interposer card out of the chassis.
Step 5. Disconnect the cables on the front OCP interposer card. For more details, see Internal Cable
Routing Guide
.
120
ThinkSystem SR630 V4 User Guide