After you finish
1. Install a new front OCP interposer card. See
“Install the front OCP interposer card” on page 121.
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install the front OCP interposer card
Follow the steps in this section to install a front OCP interposer card.
About this task
Attention:
• Read
“Installation Guidelines” on page 57 and “Safety inspection checklist” on page 58 to ensure that you
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
“Power off the server” on page 75.
• Keep static-sensitive parts in their static-protective packages until installation to prevent exposure to
static electricity. Handle the parts with an electrostatic-discharge wrist strap or other grounding systems.
Place the parts on a static-protective surface.
Procedure
Step 1. Remove the top cover. See “Remove the top cover” on page 282.
Step 2. Connect the cables to the front OCP interposer card. For more details, see
Internal Cable Routing
Guide
.
Step 3. Install the front OCP interposer card to the chassis.
Figure 115. Installing the front OCP interposer card
a. Place the front OCP interposer card on the chassis, and align the screw holes.
b.
Tighten four screws.
c.
Connect the sideband connector.
After you finish
Chapter 5. Hardware replacement procedures 121
To Next Page
Loading...
