Figure 124. Remove a drive filler
Step 2. Install the drive in the drive bay.
Figure 125. Hot-swap drive installation
a. Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay
until it snaps into position.
b.
Close the drive tray handle to lock the drive in place.
Step 3. Check the drive LEDs to verify that the drive is operating normally. For details, see
“Drive LEDs” on
page 36
.
Step 4. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you removed it. See
“Install the security bezel” on page 261.
2. Use the Lenovo XClarity Provisioning Manager to configure the RAID if necessary. For more information,
see:
https://pubs.lenovo.com/lxpm-overview/.
Chapter 5. Hardware replacement procedures 131
To Next Page
Loading...
