Figure 143. Removing the intrusion switch
a. Disconnect the cable of the intrusion switch from the processor board. For the location of
the intrusion switch connector and cable routing information, refer to
“System-board-assembly
connectors” on page 32
and Internal Cable Routing Guide. Route the cable out of the cable
clip.
b. Insert the tip of a slotted screwdriver into the gap between the cage and switch and push
outwards.
c.
Slide the intrusion switch as shown to remove it.
Step 4. Re-install the system fan-pack 2. Align the four corners of the fan-pack to its socket and put it
down.
Figure 144. Re-installing fan-pack 2
After you finish
148 ThinkSystem SR630 V4 User Guide
To Next Page
Loading...
