Lenovo ThinkSystem SR630 V4 - Page 162

Step 3. Disconnect the leak detection cable and pump cables from the processor board. See Internal
Cable Routing Guide
.
Step 4. Open the NeptAir module handle.
Figure 148. Opening the handle
Step 5. Disengage the NeptAir module from processors.
Figure 149. Removing the NeptAir module
a. Fully loosen the Torx T30 nuts on the cold plate assembly and radiator.
b.
Rotate the anti-tilt wire bails inward.
152
ThinkSystem SR630 V4 User Guide