a. Loosen the six screws on the NeptAir module shipping tray.
b.
Lift the NeptAir module by the module handle (NeptAir heat sink bracket) to separate the
module from the shipping tray.
Step 3. Make sure you have an alcohol cleaning pad available.
Attention: If there is any old thermal grease on the processors, gently clean the top of the
processors with an alcohol cleaning pad.
Step 4. Install the processor to the NeptAir module.
1. Align the triangular mark on the cold plate assembly label with the triangular mark on the
processor carrier and processor.
2. Install the NeptAir module onto the processor-carrier.
3. Press the carrier into place until the clips at all four corners engage.
Note: If your server only has one processor installed, generally processor 1, it is required to install
a cover to the empty socket of processor 2 before proceeding with further installation.
Chapter 5. Hardware replacement procedures 155
To Next Page
Loading...
