Figure 198. Removing the manifold
a. Hold the manifold with both hands, and lift it upward to relocate the spools from the small
openings to large ones on the rack cabinet.
b.
Remove the manifold with the hose kit attached.
Step 5. Repeat
Step 4 on page 192 to the other manifold.
Notes:
• There is remaining liquid inside the manifold and the hose kit. Remove both together and leave
the further draining to the next step.
• For more information about the rack cabinet, see
ThinkSystem Heavy Duty Full Depth Rack
Cabinets User Guide
.
Step 6. Install the bleeder kit to the manifold supply side.
Note: This step drains the liquid with the help of a pressure difference inside and outside the
supply manifold.
Chapter 5. Hardware replacement procedures 193
To Next Page
Loading...
