4 Nut and wire bail retainer 12 Processor ejector handle
5 Torx T30 nut 13 Thermal grease
6 Anti-tilt wire bail 14 Processor heat spreader
7 Clips to secure carrier to a heat sink
15 Processor triangular mark
8 Processor carrier code marking 16 Processor contacts
Torque screwdriver type list
Screw Type
Torx T30 head screwdriver Torx T30 screw
Procedure
Step 1. If you are replacing a processor and reusing the heat sink.
a. Remove the processor identification label from the heat sink and replace it with the new label
that comes with the replacement processor.
b. If there is any old thermal grease on the heat sink, wipe the thermal grease from the bottom of
the heat sink with an alcohol cleaning pad.
Step 2. If you are replacing a heat sink and reusing the processor.
a. Remove the processor identification label from the old heat sink and place it on the new heat
sink in the same location. The label is on the side of the heat sink closest to the triangular
alignment mark.
Note: If you are unable to remove the label and place it on the new heat sink, or if the label is
damaged during transfer, write the processor serial number from the processor identification
label on the new heat sink in the same location as the label would be placed using a permanent
marker.
b. Install processor in new carrier.
Figure 227. Installing a processor carrier
Chapter 5. Hardware replacement procedures 227
To Next Page
Loading...
